100% Guaranteed Genuine Parts
56461P Speed Queen Washer Dryer Idler/Rolley Pulley Shaft
56461P Speed Queen Washer Dryer Idler/Rolley Pulley Shaft
Weight : 0.03 lbs
Dimension : 4.88 x 1.14 x 0.75
Compatible Brands
About this product
56461P Speed Queen Washer Dryer Idler/Rolley Pulley Shaft
Weight : 0.03 lbs
Dimension : 4.88 x 1.14 x 0.75
The following parts are replaced by this product
- 56461
- 56461
- 38228
Replacing the 56461P Speed Queen Washer/Dryer Idler Pulley Shaft
Materials Required:
-Replacement idler pulley shaft for the 56461P Speed Queen Washer/Dryer
-Screwdriver
-Pliers
-Towel
Instructions:
1. Unplug your washer/dryer from the wall power source and shut off any water valves connected to it.
2. Place the towel underneath the washer/dryer to protect the floor.
3. Locate the idler pulley shaft located at the back of the machine and unscrew the screws that hold it in place with a screwdriver.
4. Slide the old idler pulley shaft out of its housing and discard it.
5. Insert the new idler pulley shaft into the housing, ensuring that it is properly seated.
6. Securely fasten the screws with the screwdriver.
7. Re-connect the power source and water valves if necessary.
8. Turn on the washer/dryer and use a pliers to ensure that the new idler pulley shaft is spinning correctly.
9. You’re done! Enjoy your freshly replaced 56461P Speed Queen Washer/Dryer Idler Pulley Shaft.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Materials Required:
-Replacement idler pulley shaft for the 56461P Speed Queen Washer/Dryer
-Screwdriver
-Pliers
-Towel
Instructions:
1. Unplug your washer/dryer from the wall power source and shut off any water valves connected to it.
2. Place the towel underneath the washer/dryer to protect the floor.
3. Locate the idler pulley shaft located at the back of the machine and unscrew the screws that hold it in place with a screwdriver.
4. Slide the old idler pulley shaft out of its housing and discard it.
5. Insert the new idler pulley shaft into the housing, ensuring that it is properly seated.
6. Securely fasten the screws with the screwdriver.
7. Re-connect the power source and water valves if necessary.
8. Turn on the washer/dryer and use a pliers to ensure that the new idler pulley shaft is spinning correctly.
9. You’re done! Enjoy your freshly replaced 56461P Speed Queen Washer/Dryer Idler Pulley Shaft.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Write Your Own Review