D513710 Speed Queen Cylinder Glide

How to Replace the D513710 Speed Queen Dryer Cylinder Glide

1. Unplug your dryer and move it to an area with plenty of room to work in.

2.Lay the dryer on its back.

3.Remove the screws that are holding the lint trap in place.

4.Remove the lint trap and set aside.

5.Locate the cylinder glide, which is held in place by two screws.

6.Remove the screws and take out the old cylinder glide.

7.Apply a small amount of lubricant to the edges of the replacement cylinder glide.

8. Insert the cylinder glide into place and replace the screws that were used to hold it there.

9.Replace the lint trap and secure it with the screws.

10.Flip your dryer back upright and plug it in.

11.Test the dryer toggle switch to make sure the cylinder glide is working properly.

12.Enjoy your newly functioning dryer!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.