D510142P Speed Queen Dryer Idler Pulley Wheel and Bearing
Idler pulley wheel and bearing works with some Speed Queen, and Amana models of clothes dryers.
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
Idler pulley wheel and bearing works with some Speed Queen, and Amana models of clothes dryers.
Write Your Own Review
The following parts are replaced by this product
- 510142
- 510142P
- 510142
- 510142
DIY Steps to Replace a Speed Queen Dryer Idler Pulley Wheel and Bearing (D510142P)
1. Safety First: Before performing any DIY maintenance, make sure that you unplug the dryer and wear safety glasses during installation.
2. Prepare for the Replacement: You will need a Phillips head screwdriver, pliers and a socket wrench for this step.
3. Removing the Existing Idler Pulley: Open the dryer door and locate the rear access panel. Remove the panel with a Phillips head screwdriver. Locate the existing idler pulley wheel and bearing, which is held in place by two screws. Remove the screws with a socket wrench and pull the pulley and bearing away from the motor.
4. Installing the New Idler Pulley: Insert the new idler pulley wheel and bearing into position and use the socket wrench to tighten the screws. Make sure that the wheel and bearing are securely in place.
5. Check for Proper Alignment: Pull the belt with your hand and the wheel should rotate freely. If the wheel or bearing is not properly aligned with the wheel, use a pair of pliers to adjust it.
6. Finishing Up: Replace the rear access panel, plug the dryer back in and test the dryer to make sure that the replacement was successful.
By following these steps, you should now have successfully replaced the Speed Queen Dryer Idler Pulley Wheel and Bearing (D510142P). Remember to take safety precautions when doing DIY projects at home and make sure that all parts are properly installed!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Safety First: Before performing any DIY maintenance, make sure that you unplug the dryer and wear safety glasses during installation.
2. Prepare for the Replacement: You will need a Phillips head screwdriver, pliers and a socket wrench for this step.
3. Removing the Existing Idler Pulley: Open the dryer door and locate the rear access panel. Remove the panel with a Phillips head screwdriver. Locate the existing idler pulley wheel and bearing, which is held in place by two screws. Remove the screws with a socket wrench and pull the pulley and bearing away from the motor.
4. Installing the New Idler Pulley: Insert the new idler pulley wheel and bearing into position and use the socket wrench to tighten the screws. Make sure that the wheel and bearing are securely in place.
5. Check for Proper Alignment: Pull the belt with your hand and the wheel should rotate freely. If the wheel or bearing is not properly aligned with the wheel, use a pair of pliers to adjust it.
6. Finishing Up: Replace the rear access panel, plug the dryer back in and test the dryer to make sure that the replacement was successful.
By following these steps, you should now have successfully replaced the Speed Queen Dryer Idler Pulley Wheel and Bearing (D510142P). Remember to take safety precautions when doing DIY projects at home and make sure that all parts are properly installed!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
