Online Sale!
100% Guaranteed Genuine Parts
W11366249 Whirlpool Washer Tub to Pump Hose
Tub-to-pump hose works with some Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models of washing machines.
Weight : 1.79 lbs
Dimension : 9.96 x 5.83 x 4.29
Compatible Brands
About this product
Tub-to-pump hose works with some Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models of washing machines.
Weight : 1.79 lbs
Dimension : 9.96 x 5.83 x 4.29
The following parts are replaced by this product
- 8540012
- WP8540012
- W10609566
Replacing the W11366249 Whirlpool Washer Tub-To-Pump Hose: DIY Instructions
This guide will provide you with step by step instructions on how to replace the Whirlpool Washer Tub-To-Pump Hose (W11366249).
Step 1: Unplug the washer from the power source and turn off the water.
Step 2: Disconnect the old hose from the pump and the tub.
Step 3: Place the new hose in a bucket filled with warm water to make it easier to install.
Step 4: Connect one end of the new hose to the tub. Use pliers to tighten the clamps on both sides of the connection.
Step 5: Connect the other end of the new hose to the pump. Again, use pliers to tighten the clamps on both sides of the connection.
Step 6: Once the new hose is in place, turn the water back on and plug the washer back into the power source.
Congratulations! You have successfully replaced the Whirlpool Washer Tub-To-Pump Hose (W11366249).
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
This guide will provide you with step by step instructions on how to replace the Whirlpool Washer Tub-To-Pump Hose (W11366249).
Step 1: Unplug the washer from the power source and turn off the water.
Step 2: Disconnect the old hose from the pump and the tub.
Step 3: Place the new hose in a bucket filled with warm water to make it easier to install.
Step 4: Connect one end of the new hose to the tub. Use pliers to tighten the clamps on both sides of the connection.
Step 5: Connect the other end of the new hose to the pump. Again, use pliers to tighten the clamps on both sides of the connection.
Step 6: Once the new hose is in place, turn the water back on and plug the washer back into the power source.
Congratulations! You have successfully replaced the Whirlpool Washer Tub-To-Pump Hose (W11366249).
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Write Your Own Review