804428P Speed Queen Black Door Seal Assembly

How to Replace the Speed Queen 804428P ASSY, Door Seal (Black) - Coin

Keeping your Speed Queen washer-dryer in good repair is essential to maintain its performance and efficiency. If you notice excessive noise during the washing cycle, it may be time to replace the door seal. Replacing the Speed Queen 804428P ASSY, Door Seal (Black) - Coin is an easy DIY job that only takes about 15 minutes. Here are the steps for replacing the seal:

1. Unplug the Speed Queen washer-dryer from the power outlet and turn off the water supply.

2. Pull the machine away from the wall and locate the existing door seal.

3. Loosen the screws holding the seal in place and carefully remove it.

4. Take a look at the new seal and make sure all the pieces are there and that none are damaged.

5. Position the new seal around the door frame. Make sure it’s snug and completely covers the opening.

6. Secure the new seal with the screws you removed earlier.

7. Reconnect the power cord and turn the water supply on.

8. Push the machine back against the wall and check for any leaks.

That's all you need to do to successfully replace the Speed Queen 804428P ASSY, Door Seal (Black) - Coin. This job should be relatively easy to do as long as you have the right parts. With a few simple steps, you can have your washing machine running smoothly again.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.