WPW10183375 Whirlpool Burner Cap
The Whirlpool WPW10183375 CAP-BURNER is the perfect addition to any kitchen. This cap-burner is simple to install and use, so you can be up and cooking in no time. We're your #1 source for genuine OEM appliance parts. Contact us for further questions as well as any other appliance parts needs!
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
The Whirlpool WPW10183375 CAP-BURNER is the perfect addition to any kitchen. This cap-burner is simple to install and use, so you can be up and cooking in no time. We're your #1 source for genuine OEM appliance parts. Contact us for further questions as well as any other appliance parts needs!
Write Your Own Review
The following parts are replaced by this product
- W10183375
1. Start by turning off the power to your Whirlpool stove, either disconnecting it from the circuit breaker or unplugging it and flipping the switch off.
2. Remove the grates and burner caps from the top of the stove.
3. Place a towel over the electric coils to protect them from any debris or dirt.
4. Unscrew the old burner cap by using a Phillips head screwdriver and gently pushing the old cap out of its place.
5. Take out the new burner cap and insert it in place of the old one. Make sure to align the holes for the electric coils with the new cap.
6. Secure the new cap in place by using the Phillips head screwdriver and tightening the screws until the cap is secure.
7. Replace the grates and burner caps and turn the power on to the stove again.
8. Perform a test run by turning on the power and heating the electric coil. Ensure the coil is working properly and there is no risk of damage or fire hazard when operating the stove.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
2. Remove the grates and burner caps from the top of the stove.
3. Place a towel over the electric coils to protect them from any debris or dirt.
4. Unscrew the old burner cap by using a Phillips head screwdriver and gently pushing the old cap out of its place.
5. Take out the new burner cap and insert it in place of the old one. Make sure to align the holes for the electric coils with the new cap.
6. Secure the new cap in place by using the Phillips head screwdriver and tightening the screws until the cap is secure.
7. Replace the grates and burner caps and turn the power on to the stove again.
8. Perform a test run by turning on the power and heating the electric coil. Ensure the coil is working properly and there is no risk of damage or fire hazard when operating the stove.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
No more associated models for this part.
