Online Sale!
100% Guaranteed Genuine Parts
WPW10531320 Whirlpool Drain Pump
WPW10531320 Whirlpool Drain Pump
Weight : 0.773100 lbs
Dimension : 5.590500 x 4.606200 x 4.173200
Compatible Brands
About this product
WPW10531320 Whirlpool Drain Pump
Weight : 0.773100 lbs
Dimension : 5.590500 x 4.606200 x 4.173200
The following parts are replaced by this product
- W10531320
No more associated models for this part.
Step-by-Step DIY Instructions for Replacing the Whirlpool WPW10531320 Pump-Drain
Before you start, make sure to unplug the appliance and shut off all water sources.
1. Locate and remove the back panel of your dishwasher. This will allow access to the pump-drain.
2. Remove any clamps or hoses attached to the pump-drain and disconnect the drain hose from the drain.
3. Remove the screws that secure the pump-drain in place, and then gently lift it out of the dishwasher.
4. Compare the old pump-drain with the replacement part to make sure they match.
5. Install the replacement pump-drain into the dishwasher, ensuring that it is secure by using the screws that were removed.
6. Reattach the drain hose and any clamps or hoses that were disconnected.
7. Replace the back panel of the dishwasher.
8. Plug the dishwasher back in and turn on the water.
9. Test the dishwasher to make sure everything is working properly.
Congratulations! You have successfully replaced the Whirlpool WPW10531320 Pump-Drain.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Before you start, make sure to unplug the appliance and shut off all water sources.
1. Locate and remove the back panel of your dishwasher. This will allow access to the pump-drain.
2. Remove any clamps or hoses attached to the pump-drain and disconnect the drain hose from the drain.
3. Remove the screws that secure the pump-drain in place, and then gently lift it out of the dishwasher.
4. Compare the old pump-drain with the replacement part to make sure they match.
5. Install the replacement pump-drain into the dishwasher, ensuring that it is secure by using the screws that were removed.
6. Reattach the drain hose and any clamps or hoses that were disconnected.
7. Replace the back panel of the dishwasher.
8. Plug the dishwasher back in and turn on the water.
9. Test the dishwasher to make sure everything is working properly.
Congratulations! You have successfully replaced the Whirlpool WPW10531320 Pump-Drain.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Write Your Own Review