Online Sale!
100% Guaranteed Genuine Parts
WP67001360 Whirlpool Power Supply Control Board
WP67001360 Whirlpool Control Board Power Supply
Weight : 0.467600 lbs
Dimension : 6.968500 x 4.015700 x 2.322800
Compatible Brands
About this product
WP67001360 Whirlpool Control Board Power Supply
Weight : 0.467600 lbs
Dimension : 6.968500 x 4.015700 x 2.322800
The following parts are replaced by this product
- 67001360
- 102937
No more associated models for this part.
1. Turn off the power to your Whirlpool appliance by unplugging it or cutting off its power at the circuit breaker.
2. Remove the backaccess panel of your appliance and locate the WP67001360 control board.
3. Disconnect any wires connected to the control board and remove the mounting screws holding it in place.
4. Unscrew the terminals from the panel and unscrew the terminals from the board itself.
5. Insert the new WP67001360 control board into the same slot where the old board was, ensuring the terminals line up correctly.
6. Attach the terminals to the board and secure them with the mounting screws.
7. Attach the wires to the correct terminal on the board. Make sure to use the wiring diagram for reference.
8. Carefully slide the panel back on, ensuring all wiring is protected, and secure it with the mounting screws.
9. Replace the circuit breaker or plug the appliance back in and test the controls to ensure they are operating properly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
2. Remove the backaccess panel of your appliance and locate the WP67001360 control board.
3. Disconnect any wires connected to the control board and remove the mounting screws holding it in place.
4. Unscrew the terminals from the panel and unscrew the terminals from the board itself.
5. Insert the new WP67001360 control board into the same slot where the old board was, ensuring the terminals line up correctly.
6. Attach the terminals to the board and secure them with the mounting screws.
7. Attach the wires to the correct terminal on the board. Make sure to use the wiring diagram for reference.
8. Carefully slide the panel back on, ensuring all wiring is protected, and secure it with the mounting screws.
9. Replace the circuit breaker or plug the appliance back in and test the controls to ensure they are operating properly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Write Your Own Review