803667 Speed Queen Dispenser Drawer

DIY Instructions for Replacing a Speed Queen 803667 Drawer Dispenser

1. Prepare for the replacement by unplugging the Speed Queen 803667 drawer dispenser from the power outlet.

2. Remove the entire drawer assembly from the washer. Use a Phillips head screwdriver to unscrew the screws located at the bottom of the washer.

3. Lift the drawer up and off the washer. You may need to wiggle the drawer slightly to loosen it from the track.

4. Place the old drawer into a safe place for later disposal.

5. Carefully inspect the new drawer for any damage before installation.

6. Locate the track in the washer and line up the new drawer with it.

7. Push the drawer into the track as far as it will go.

8. Secure the drawer by screwing in the screws on the bottom of the washer.

9. Re-plug the Speed Queen 803667 drawer dispenser into the power outlet and test its functions.

10. Clean up any mess and dispose of the old drawer responsibly.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.