Online Sale!
100% Guaranteed Genuine Parts
WH49X10042 GE Agitator Coupling Kit
General Electric / RCA / Hotpoint Washer Agitator Drive Bell Coupler WH49X10042
We are a Factory Authorized Parts Distributor for General Electric. Trust us for all of your General Electric appliance parts and accessories needs.
We are a Factory Authorized Parts Distributor for General Electric. Trust us for all of your General Electric appliance parts and accessories needs.
Weight : 0.311000 lbs
Dimension : 3.779500 x 3.543300 x 3.228300
Compatible Brands
About this product
General Electric / RCA / Hotpoint Washer Agitator Drive Bell Coupler WH49X10042
We are a Factory Authorized Parts Distributor for General Electric. Trust us for all of your General Electric appliance parts and accessories needs.
We are a Factory Authorized Parts Distributor for General Electric. Trust us for all of your General Electric appliance parts and accessories needs.
Weight : 0.311000 lbs
Dimension : 3.779500 x 3.543300 x 3.228300
The following parts are replaced by this product
- WH02X10037
- WH43X10009
- WH43X137
- WH2X1200
- WH02X1200
- WH43X0137
- WH49X10042-25PK
No more associated models for this part.
1. Begin by unplugging the washer from the wall outlet.
2. Next, remove the two clips holding the end of the drive tube to the motor.
3. Carefully remove the washer top panel and then loop the belt off the motor pulley.
4. Disconnect the water hose from the inlet valve and remove the two screws securing the inlet valve to the cabinet.
5. Lift the inlet valve out of the washer to gain access to the coupling.
6. The WH49X10042 coupling will be located underneath the inlet valve.
7. Gently pry the coupling off the motor shaft and then remove the three screws that are securing it to the cabinet.
8. Install the new WH49X10042 coupling by attaching it to the motor shaft, reattaching the three screws, and replacing the inlet valve.
9. Loop the belt back onto the motor pulley and then reconnect the clips securing the drive tube to the motor.
10. Reconnect the water hose to the inlet valve and replace the washer top panel.
11. Lastly, plug the washer back into the wall outlet, and you're done!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
2. Next, remove the two clips holding the end of the drive tube to the motor.
3. Carefully remove the washer top panel and then loop the belt off the motor pulley.
4. Disconnect the water hose from the inlet valve and remove the two screws securing the inlet valve to the cabinet.
5. Lift the inlet valve out of the washer to gain access to the coupling.
6. The WH49X10042 coupling will be located underneath the inlet valve.
7. Gently pry the coupling off the motor shaft and then remove the three screws that are securing it to the cabinet.
8. Install the new WH49X10042 coupling by attaching it to the motor shaft, reattaching the three screws, and replacing the inlet valve.
9. Loop the belt back onto the motor pulley and then reconnect the clips securing the drive tube to the motor.
10. Reconnect the water hose to the inlet valve and replace the washer top panel.
11. Lastly, plug the washer back into the wall outlet, and you're done!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Write Your Own Review