WPW10204131 Whirlpool Dishwasher Dishrack Adjuster
Part #: WPL WPW10204131
Dishrack adjuster works with some Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models of dishwashers.
Dishrack adjuster works with some Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models of dishwashers.
Write Your Own Review
DIY Guide for Replacing a Whirlpool Dishwasher Dishrack Adjuster (WPW10204131)
Are your dishes not fitting correctly in your dishwasher's dish rack? This may be due to a faulty or worn out dishrack adjuster. Replacing the adjuster is a simple task that can be done with a few basic tools and supplies. Follow these steps to properly replace a WPW10204131 Whirlpool dishwasher dishrack adjuster.
1. Unplug the power cord to the dishwasher from the wall outlet.
2. Open the dishwasher door and locate the adjuster. The adjuster will usually be located at the bottom of the dishwasher, on the right side.
3. Use a screwdriver to remove the screws that hold the adjuster in place.
4. Pull the adjuster away from the dishwasher and remove any debris from the area.
5. Place the new adjuster in the same location and secure it with the screws.
6. Reconnect the power cord to the wall outlet.
7. Run the dishwasher through a cycle to test the new adjuster.
By following the steps above, you should now have a properly functioning dishwasher with a working adjuster. If you have any questions or need help with the installation process, contact your local appliance repair technician.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Are your dishes not fitting correctly in your dishwasher's dish rack? This may be due to a faulty or worn out dishrack adjuster. Replacing the adjuster is a simple task that can be done with a few basic tools and supplies. Follow these steps to properly replace a WPW10204131 Whirlpool dishwasher dishrack adjuster.
1. Unplug the power cord to the dishwasher from the wall outlet.
2. Open the dishwasher door and locate the adjuster. The adjuster will usually be located at the bottom of the dishwasher, on the right side.
3. Use a screwdriver to remove the screws that hold the adjuster in place.
4. Pull the adjuster away from the dishwasher and remove any debris from the area.
5. Place the new adjuster in the same location and secure it with the screws.
6. Reconnect the power cord to the wall outlet.
7. Run the dishwasher through a cycle to test the new adjuster.
By following the steps above, you should now have a properly functioning dishwasher with a working adjuster. If you have any questions or need help with the installation process, contact your local appliance repair technician.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
