WPW10195372 Whirlpool Housing

DIY: How to Replace a Whirlpool WPW10195372 HOUSING-UNIT

Are you experiencing issues with your Whirlpool WPW10195372 HOUSING-UNIT? Replacing the part is not difficult and you can do it on your own. This step-by-step guide will walk you through the process of safely replacing your Whirlpool WPW10195372 HOUSING-UNIT.

Tools you will need:

- Phillips head screwdriver

- Flathead screwdriver

- Needle nose pliers

- Safety goggles

- Gloves

Step 1: Unplug the appliance to disconnect it from the power source. You should also shut off any water connections feeding into the machine.

Step 2: Remove the screws from the back of the washing machine. There should be two screws in the lower corners of the back panel. Use a Phillips head screwdriver to remove them.

Step 3: Lift the back panel off. Set it aside.

Step 4: Locate the Whirlpool WPW10195372 HOUSING-UNIT. It should be to the left of the control board.

Step 5: Disconnect wires and hoses connected to the unit. Make sure to keep track of which wires go where.

Step 6: Use the flathead screwdriver to remove the screws holding the Whirlpool WPW10195372 HOUSING-UNIT in place.

Step 7: Unhook the unit from the wall. If needed, use needle nose pliers to loosen stubborn connections.

Step 8: Place the new Whirlpool WPW10195372 HOUSING-UNIT in the opening and reconnect the wires and hoses.

Step 9: Replace the back panel and secure it with the screws.

Step 10: Reconnect any water sources and plug the machine back in. Test the unit to make sure it works properly.

Congratulations! You have successfully replaced your Whirlpool WPW10195372 HOUSING-UNIT.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.