W10847841 Whirlpool Range Hood Vent Damper
Vent damper works with some Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models of range hoods.
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
Vent damper works with some Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models of range hoods.
Write Your Own Review
The following parts are replaced by this product
- W10592040
Step-by-Step Instructions on Replacing a Whirlpool Range Hood Vent Damper (W10847841)
1. Start by turning off the electricity to the range hood. Unplug or flip the circuit breaker switch.
2. Remove the vent damper from the range hood. Gently pull it out of its housing and set aside.
3. Carefully remove the old damper. Using pliers or a socket wrench, loosen the screws that hold the old damper in place. Then carefully pull it off the range hood vent.
4. Install the new damper. Line up the new damper with the slots in the range hood vent. Make sure the damper is properly aligned before tightening down the screws.
5. Secure the new damper in place. Tighten the screws holding the new damper in place.
6. Turn the power back on to the range hood.
7. Test the new damper. Turn the fan on and ensure that the damper opens and closes properly.
Now that you've completed your DIY task of replacing the W10847841 Whirlpool Range Hood Vent Damper, you can enjoy the satisfaction of a job well done.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Start by turning off the electricity to the range hood. Unplug or flip the circuit breaker switch.
2. Remove the vent damper from the range hood. Gently pull it out of its housing and set aside.
3. Carefully remove the old damper. Using pliers or a socket wrench, loosen the screws that hold the old damper in place. Then carefully pull it off the range hood vent.
4. Install the new damper. Line up the new damper with the slots in the range hood vent. Make sure the damper is properly aligned before tightening down the screws.
5. Secure the new damper in place. Tighten the screws holding the new damper in place.
6. Turn the power back on to the range hood.
7. Test the new damper. Turn the fan on and ensure that the damper opens and closes properly.
Now that you've completed your DIY task of replacing the W10847841 Whirlpool Range Hood Vent Damper, you can enjoy the satisfaction of a job well done.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
No more associated models for this part.
