W10427967 Whirlpool Electronic Control Board

Step 1: Disconnect the Power
Before beginning, make sure to disconnect the power to the Whirlpool W10427967 CNTRL-ELEC by unplugging the appliance or turning off the breaker.

Step 2: Locate the Control
Find the control panel which holds the Whirlpool W10427967 CNTRL-ELEC. This is normally located behind the kick plate of the appliance or the rear of the unit, depending on the model.

Step 3: Remove Panel
Remove the screws from the control panel and carefully remove the panel.

Step 4: Unscrew the CNTRL-ELEC
Unscrew the screws that hold the Whirlpool W10427967 CNTRL-ELEC in place and gently pull the control out of the appliance.

Step 5: Install New CNTRL-ELEC
Take your replacement Whirlpool W10427967 CNTRL-ELEC and line up the mounting holes with the holes on the appliance. Secure the new control with the screws.

Step 6: Reconnect Power
Once the control is in place and all the screws are tightened, reconnect the power to the appliance and turn it on. Your Whirlpool W10427967 CNTRL-ELEC should now be installed and working properly.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.