204065P Speed Queen Washer Control Full Panel HYB TL Assembly
Control, full panel hyb tl assembly works with some Speed Queen, and Amana models of washing machines.
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
Control, full panel hyb tl assembly works with some Speed Queen, and Amana models of washing machines.
Write Your Own Review
The following parts are replaced by this product
- 204065
Step 1: Unplug the Washer – Before beginning any repair, ensure that the washer is unplugged from the wall outlet.
Step 2: Remove the Control Panel – To remove the control panel, unscrew the screws around the sides and bottom of the panel, then carefully pull the panel off to access the control assembly.
Step 3: Disconnect Wires – Before removing the old control assembly, disconnect the wires from the back of the assembly by carefully pulling them away from the clips.
Step 4: Install New Control Assembly – Place the new 204065P Speed Queen Washer Control Assembly onto the control panel and reconnect the wires. Tighten the screws to secure the assembly.
Step 5: Re-Attach Control Panel – Gently slide the control panel back into place and tighten the screws to secure the control panel in place.
Step 6: Plug the Washer In – Finally, plug the washer back into the wall outlet to test the new control assembly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Step 2: Remove the Control Panel – To remove the control panel, unscrew the screws around the sides and bottom of the panel, then carefully pull the panel off to access the control assembly.
Step 3: Disconnect Wires – Before removing the old control assembly, disconnect the wires from the back of the assembly by carefully pulling them away from the clips.
Step 4: Install New Control Assembly – Place the new 204065P Speed Queen Washer Control Assembly onto the control panel and reconnect the wires. Tighten the screws to secure the assembly.
Step 5: Re-Attach Control Panel – Gently slide the control panel back into place and tighten the screws to secure the control panel in place.
Step 6: Plug the Washer In – Finally, plug the washer back into the wall outlet to test the new control assembly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
