100% Guaranteed Genuine Parts
202884 Speed Queen Valve To Inlet Hose
202884 Speed Queen Valve Valve To Inlet Hose
Weight : 0.468500 lbs
Dimension : 7.716500 x 4.763700 x 1.771600
About this product
202884 Speed Queen Valve Valve To Inlet Hose
Weight : 0.468500 lbs
Dimension : 7.716500 x 4.763700 x 1.771600
DIY Guide for Replacing the Speed Queen 202884 HOSE,VALVE TO INLET
Replacing the Speed Queen 202884 HOSE,VALVE TO INLET is a relatively simple task. This guide will provide you with all the instructions needed to replace the hose, so your washing machine can be back up and running in no time.
What You’ll Need:
• Speed Queen 202884 HOSE,VALVE TO INLET replacement
• Wrench
• Screwdriver
• Pliers
• Small bucket
Instructions:
1. First, turn off the power to the washing machine by pulling the plug out of the wall outlet.
2. Use the wrench to unscrew the union nuts connecting the water supply line to the inlet valve at both ends.
3. Put the small bucket under the inlet valve to catch any residual water that may be in the line.
4. Use the screwdriver to disconnect the clamps that hold the old Speed Queen 202884 HOSE,VALVE TO INLET in place.
5. Carefully remove the old hose from the inlet valve and discard it.
6. Take the new Speed Queen 202884 HOSE,VALVE TO INLET and attach it to the inlet valve.
7. Secure the new hose to the inlet valve with the clamps from earlier.
8. Use the pliers to tighten the clamps and then reattach the water supply line to the inlet valve.
9. Finally, plug the washing machine back into the wall outlet, turn on the power, and test to make sure that the hose is properly attached and functioning correctly.
Congratulations – you’ve successfully replaced the Speed Queen 202884 HOSE,VALVE TO INLET!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Replacing the Speed Queen 202884 HOSE,VALVE TO INLET is a relatively simple task. This guide will provide you with all the instructions needed to replace the hose, so your washing machine can be back up and running in no time.
What You’ll Need:
• Speed Queen 202884 HOSE,VALVE TO INLET replacement
• Wrench
• Screwdriver
• Pliers
• Small bucket
Instructions:
1. First, turn off the power to the washing machine by pulling the plug out of the wall outlet.
2. Use the wrench to unscrew the union nuts connecting the water supply line to the inlet valve at both ends.
3. Put the small bucket under the inlet valve to catch any residual water that may be in the line.
4. Use the screwdriver to disconnect the clamps that hold the old Speed Queen 202884 HOSE,VALVE TO INLET in place.
5. Carefully remove the old hose from the inlet valve and discard it.
6. Take the new Speed Queen 202884 HOSE,VALVE TO INLET and attach it to the inlet valve.
7. Secure the new hose to the inlet valve with the clamps from earlier.
8. Use the pliers to tighten the clamps and then reattach the water supply line to the inlet valve.
9. Finally, plug the washing machine back into the wall outlet, turn on the power, and test to make sure that the hose is properly attached and functioning correctly.
Congratulations – you’ve successfully replaced the Speed Queen 202884 HOSE,VALVE TO INLET!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Write Your Own Review