DG94-00520A Samsung Hot Surface Ignitor
Hot surface burner igniter assembly for some models of Samsung gas range ovens.
Hot surface burner igniter assembly for some models of Samsung gas range ovens.
Write Your Own Review
1. First, safety comes first - make sure to unplug your appliance before doing any DIY repair work.
2. Next, locate the DG94-00520A Samsung Hot Surface Ignitor in your appliance. It should be attached to the burner assembly.
3. Remove the two screws securing the ignitor to the burner assembly.
4. Detach the spark plug wire from the old ignitor and set it aside.
5. Now remove the two main terminal wires from the old ignitor.
6. Carefully take the old ignitor out of the appliance and discard it.
7. Take your new DG94-00520A Samsung Hot Surface Ignitor and attach the two main terminal wires to their respective terminals on the ignitor.
8. Connect the spark plug wire to the designated terminal on the new ignitor.
9. Place the new ignitor in the burner assembly, making sure that all wires are secure and not pinched under the ignitor.
10. Secure the new ignitor with the two screws you removed earlier.
11. Double check that everything is connected properly and securely before plugging in your appliance and turning it back on.
Following these simple steps will help you successfully replace your DG94-00520A Samsung Hot Surface Ignitor. Good luck!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
2. Next, locate the DG94-00520A Samsung Hot Surface Ignitor in your appliance. It should be attached to the burner assembly.
3. Remove the two screws securing the ignitor to the burner assembly.
4. Detach the spark plug wire from the old ignitor and set it aside.
5. Now remove the two main terminal wires from the old ignitor.
6. Carefully take the old ignitor out of the appliance and discard it.
7. Take your new DG94-00520A Samsung Hot Surface Ignitor and attach the two main terminal wires to their respective terminals on the ignitor.
8. Connect the spark plug wire to the designated terminal on the new ignitor.
9. Place the new ignitor in the burner assembly, making sure that all wires are secure and not pinched under the ignitor.
10. Secure the new ignitor with the two screws you removed earlier.
11. Double check that everything is connected properly and securely before plugging in your appliance and turning it back on.
Following these simple steps will help you successfully replace your DG94-00520A Samsung Hot Surface Ignitor. Good luck!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
