DC97-07510B Samsung Dryer Door Lever Holder Catch Assembly
Door catch lever holder assembly for some models of Samsung dryers.
Door catch lever holder assembly for some models of Samsung dryers.
Write Your Own Review
DIY Guide to Replacing the DC97-07510B Samsung Dryer Door Lever Holder Catch Assembly
Are the hinges on your Samsung dryer door not catching securely? It may be time to replace the DC97-07510B Samsung Dryer Door Lever Holder Catch Assembly. Replacing the lever holder catch assembly is a simple DIY fix that requires basic hand tools and a few minutes of time.
Step 1: Preparing to Replace the Lever Holder Catch Assembly
Before you begin replacing the lever holder catch assembly, you will need to gather a few supplies. You will need:
• Phillips screwdriver
• Pliers
• New DC97-07510B Samsung Dryer Door Lever Holder Catch Assembly
Once you have gathered the necessary supplies, shut off the power to the dryer by unplugging it or tripping the breaker to the circuit.
Step 2: Removing the Old Lever Holder Catch Assembly
Using your screwdriver, remove the four screws securing the top of the dryer panel in place. Carefully lift up the panel to access the bottom of the dryer door.
Next, locate the old lever holder catch assembly. Use your pliers to remove the catch assembly from the dryer door.
Step 3: Installing the New Lever Holder Catch Assembly
Take the new lever holder catch assembly and slide the prongs into the slots located on the dryer door. Now secure the new assembly with the two screws provided in the kit.
Step 4: Finishing Up
Replace the front panel of the dryer, then secure the panel using the four screws removed in step 2. Finally, you can restore power to the dryer and test the new lever holder catch assembly for proper operation.
Congratulations! You have successfully replaced the DC97-07510B Samsung Dryer Door Lever Holder Catch Assembly. Enjoy your newly functioning dryer door!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Are the hinges on your Samsung dryer door not catching securely? It may be time to replace the DC97-07510B Samsung Dryer Door Lever Holder Catch Assembly. Replacing the lever holder catch assembly is a simple DIY fix that requires basic hand tools and a few minutes of time.
Step 1: Preparing to Replace the Lever Holder Catch Assembly
Before you begin replacing the lever holder catch assembly, you will need to gather a few supplies. You will need:
• Phillips screwdriver
• Pliers
• New DC97-07510B Samsung Dryer Door Lever Holder Catch Assembly
Once you have gathered the necessary supplies, shut off the power to the dryer by unplugging it or tripping the breaker to the circuit.
Step 2: Removing the Old Lever Holder Catch Assembly
Using your screwdriver, remove the four screws securing the top of the dryer panel in place. Carefully lift up the panel to access the bottom of the dryer door.
Next, locate the old lever holder catch assembly. Use your pliers to remove the catch assembly from the dryer door.
Step 3: Installing the New Lever Holder Catch Assembly
Take the new lever holder catch assembly and slide the prongs into the slots located on the dryer door. Now secure the new assembly with the two screws provided in the kit.
Step 4: Finishing Up
Replace the front panel of the dryer, then secure the panel using the four screws removed in step 2. Finally, you can restore power to the dryer and test the new lever holder catch assembly for proper operation.
Congratulations! You have successfully replaced the DC97-07510B Samsung Dryer Door Lever Holder Catch Assembly. Enjoy your newly functioning dryer door!
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
