DC32-00007A Samsung Dryer Thermistor Sensor

1. Start by unplugging the Samsung dryer from the wall outlet and turning off the power to the unit.

2. Remove the back panel of the dryer. To do this, you will need to remove several screws along the back and side panels of the dryer.

3. Disconnect the terminals of the DC32-00007A Samsung dryer thermistor sensor. This should be located in the lower right corner of the unit and have two wires connected to it.

4. Carefully pull out the old thermistor sensor and inspect it for any type of damage or corrosion.

5. Take the new thermistor sensor and make sure that it will fit easily into the designated space.

6. Connect the two wires that are connected to the new thermistor sensor. Make sure to double-check all connections.

7. Reattach the back panel of the dryer and secure it with the appropriate screws.

8. Plug in the dryer and turn on the power to the unit.

9. Test the dryer to make sure that it is running properly and that the thermistor sensor replacement was successful.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.