WR17X20449 GE Refrigerator Dispenser Actuator
The GE WR17X20449 Paddle Assembly. We're your #1 source for genuine OEM appliance parts. Contact us for further questions as well as any other appliance parts needs!
The GE WR17X20449 Paddle Assembly. We're your #1 source for genuine OEM appliance parts. Contact us for further questions as well as any other appliance parts needs!
Write Your Own Review
1. Unplug the refrigerator from the power source.
2. Locate the water hose connected to the back of the refrigerator and disconnect it.
3. Move the refrigerator away from the wall and locate the access panel located on the rear of the fridge.
4. Remove the screws or clips holding the access panel.
5. Carefully remove the access panel to expose the GE WR17X20449 Paddle Assembly.
6. Carefully disconnect the electrical wiring connected to the paddle assembly.
7. Loosen the clamps that are holding the paddle assembly in place.
8. Carefully remove the old paddle assembly and discard it.
9. Place the new paddle assembly in the same location as the old one.
10. Tighten the clamps that are holding the paddle assembly in place.
11. Reconnect the electrical wiring to the paddle assembly.
12. Replace the access panel, ensuring that all screws and clips are securely tightened.
13. Reattach the water hose to the back of the refrigerator.
14. Plug the refrigerator back in and turn it on.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
2. Locate the water hose connected to the back of the refrigerator and disconnect it.
3. Move the refrigerator away from the wall and locate the access panel located on the rear of the fridge.
4. Remove the screws or clips holding the access panel.
5. Carefully remove the access panel to expose the GE WR17X20449 Paddle Assembly.
6. Carefully disconnect the electrical wiring connected to the paddle assembly.
7. Loosen the clamps that are holding the paddle assembly in place.
8. Carefully remove the old paddle assembly and discard it.
9. Place the new paddle assembly in the same location as the old one.
10. Tighten the clamps that are holding the paddle assembly in place.
11. Reconnect the electrical wiring to the paddle assembly.
12. Replace the access panel, ensuring that all screws and clips are securely tightened.
13. Reattach the water hose to the back of the refrigerator.
14. Plug the refrigerator back in and turn it on.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
