WH41X26574 GE Washer Dryer Drain Hose Assembly

Replacing the GE Washer/Dryer Drain Hose Assembly (Model WH41X26574): DIY Instructions

1. Turn off the main power source for the washer/dryer. You may need to unplug the appliance, or shut off its circuit breaker.

2. Locate the access panel at the base of the washer/dryer. Depending on your appliance’s layout, this may be located on the front or the top.

3. Remove the access panel using a screwdriver.

4. Use a wrench to disconnect the water hoses from the existing drain hose assembly.

5. Remove the mounting screws (if any) and the clamps holding the drain hose assembly in place.

6. Pull out the old drain hose assembly and discard it.

7. Take the new drain hose assembly and slide it into position, ensuring that the ends of the hoses are aligned properly.

8. Secure the new drain hose assembly with the mounting screws and clamps.

9. Reconnect the water hoses and make sure they are connected firmly.

10. Replace the access panel.

11. Restore the power source to the washer/dryer.

12. Test the new drain hose assembly to ensure that it is functioning properly.

Following these simple steps will help you quickly and safely replace the GE Washer/Dryer Drain Hose Assembly (Model WH41X26574). Always use caution when performing any DIY project.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.