WE4M416 GE Washer Push To Start Switch
GE General Electric RCA Hotpoint Sears Kenmore Clothes Dryer PUSH TO START SWITCH WE4M416
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
GE General Electric RCA Hotpoint Sears Kenmore Clothes Dryer PUSH TO START SWITCH WE4M416
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
Write Your Own Review
The following parts are replaced by this product
- WE4M352
- WE4M367
How to Replace a GE Push-to-Start Switch (WE4M416)
Tools and Materials:
• New GE Push to Start Switch (WE4M416)
• Phillips head screwdriver
• Wire cutters
• Needle-nose pliers
Instructions:
1. Unplug the dryer from the wall outlet.
2. Open the dryer door and locate the switch that needs to be replaced.
3. Remove the two screws holding the switch in place using a Phillips head screwdriver.
4. Disconnect the wires from the old switch. Use wire cutters to trim the wires to length, if necessary.
5. Connect the wires to the new switch using needle-nose pliers to twist the wires together.
6. Secure the switch in place with the two screws.
7. Plug the dryer back in and test the switch to ensure it is functioning properly.
8. Close the dryer door.
Your GE Push to Start Switch (WE4M416) should now be replaced.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Tools and Materials:
• New GE Push to Start Switch (WE4M416)
• Phillips head screwdriver
• Wire cutters
• Needle-nose pliers
Instructions:
1. Unplug the dryer from the wall outlet.
2. Open the dryer door and locate the switch that needs to be replaced.
3. Remove the two screws holding the switch in place using a Phillips head screwdriver.
4. Disconnect the wires from the old switch. Use wire cutters to trim the wires to length, if necessary.
5. Connect the wires to the new switch using needle-nose pliers to twist the wires together.
6. Secure the switch in place with the two screws.
7. Plug the dryer back in and test the switch to ensure it is functioning properly.
8. Close the dryer door.
Your GE Push to Start Switch (WE4M416) should now be replaced.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
