WD12X10163 GE Dishwasher Detergent and Rinse Aid Dispenser Module

Instructions for Replacing the WD12X10163 GE Dishwasher Detergent and Rinse Aid Dispenser Module

Tools Needed:
-Phillips head screwdriver
-Pliers
-Replacement part (WD12X10163 GE Dishwasher Detergent and Rinse Aid Dispenser Module)

Step 1: Unplug the power cord from the outlet supplying electricity to your dishwasher. This is an important safety precaution to take to avoid electric shock.

Step 2: Open the dishwasher door and locate the detergent and rinse aid dispenser module. It should be located on the inside of the door panel.

Step 3: Use a Phillips head screwdriver to remove the screws that secure the dispenser module to the door panel.

Step 4: Carefully lift the dispenser module in order to disconnect the wiring harness. Use pliers if needed to disconnect the wires.

Step 5: Remove the old dispenser module and discard it.

Step 6: Insert the replacement dispense module in the same spot where the old one was located and reattach the wiring harness.

Step 7: Secure the replacement module to the door panel with the Phillips head screws you removed in Step 3.

Step 8: Plug the power cord back into the outlet and test the new dispenser module to ensure it is working properly.

Congratulations - you have now successfully replaced the WD12X10163 GE Dishwasher Detergent and Rinse Aid Dispenser Module!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.