WD03X10026 GE Dishwasher Plunger Spring

Replacing the WD03X10026 Spring Plunger

To replace the WD03X10026 spring plunger, you will need a replacement spring and a flat-head screwdriver. Follow the steps below for a successful DIY repair.

Step 1: Unplug the appliance before beginning any repair.

Step 2: Locate the spring plunger.

Step 3: Remove the old spring plunger by using a flat-head screwdriver to pry it away from its original position.

Step 4: Insert the new spring plunger into the appliance and secure it in place with the flat-head screwdriver.

Step 5: Test the new spring plunger to ensure it is functioning properly.

Step 6: Plug the appliance back in and enjoy the repair.

By following these simple steps, you can easily replace the WD03X10026 spring plunger in your appliance. Make sure to always unplug your appliance before attempting any repairs and wear protective gear if necessary.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.