WD01X23496 GE Switch

Step 1: Turn off the power to your dishwasher by unplugging it or switching it off at the circuit breaker.

Step 2: Locate the housing for the flood switch by feeling around the underside of the dishwasher.

Step 3: Use a screwdriver to remove the screws that hold the old housing in place. Make sure you keep track of which screws go where!

Step 4: Remove the old housing and disconnect any wires that are attached to it.

Step 5: Install the new housing by following the instructions included. Ensure that all connections are tight and secure.

Step 6: Reattach the wires to the new housing, making sure to secure them properly.

Step 7: Use the screwdriver to reattach the new housing to the dishwasher.

Step 8: Turn the power back on at the circuit breaker or plug the dishwasher back in.

Step 9: Test the flood switch to ensure it is working correctly.

By following these steps, you should now have replaced the GE WD01X23496 DISHWASHER FLOOD SWITCH HOUSING.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.