Online Sale!
100% Guaranteed Genuine Parts
WD01X10104 GE Dishwasher Hose Clamp
WD01X10104 GE Dishwasher Hose Clamp
Weight : 0.129500 lbs
Dimension : 6.000000 x 6.000000 x 0.500000
Compatible Brands



About this product
WD01X10104 GE Dishwasher Hose Clamp
Weight : 0.129500 lbs
Dimension : 6.000000 x 6.000000 x 0.500000
DIY: How to Replace a GE WD01X10104 Clamp
1. Gather the required tools for the job. You will need a Phillips screwdriver, a flathead screwdriver and a pair of pliers.
2. Disconnect the power to the appliance before attempting to do any work.
3. Locate the clamp which needs to be replaced. It is usually located on the lower back panel near the base of the appliance.
4. Using a Phillips screwdriver, loosen and remove the screws that attach the clamp to the appliance.
5. Once the screws have been removed, use a pair of pliers to detach the old clamp from the appliance.
6. Take out the new clamp and examine it to make sure it is compatible with your appliance.
7. Attach the new clamp to the appliance using the two screws provided. Make sure the clamp is secured in place.
8. Carefully re-attach any electrical wires or cables that were connected to the old clamp.
9. Test the appliance to make sure the new clamp is functioning properly.
10. Re-connect the power to the appliance.
Congratulations! You have successfully replaced the GE WD01X10104 Clamp.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Gather the required tools for the job. You will need a Phillips screwdriver, a flathead screwdriver and a pair of pliers.
2. Disconnect the power to the appliance before attempting to do any work.
3. Locate the clamp which needs to be replaced. It is usually located on the lower back panel near the base of the appliance.
4. Using a Phillips screwdriver, loosen and remove the screws that attach the clamp to the appliance.
5. Once the screws have been removed, use a pair of pliers to detach the old clamp from the appliance.
6. Take out the new clamp and examine it to make sure it is compatible with your appliance.
7. Attach the new clamp to the appliance using the two screws provided. Make sure the clamp is secured in place.
8. Carefully re-attach any electrical wires or cables that were connected to the old clamp.
9. Test the appliance to make sure the new clamp is functioning properly.
10. Re-connect the power to the appliance.
Congratulations! You have successfully replaced the GE WD01X10104 Clamp.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Write Your Own Review