WB30T10155 GE Oven Stove Haliant Burner
Part #: GEN WB30T10155
Haliant burner works with some GE, Hotpoint, and RCA models of stoves / ovens / ranges.
Haliant burner works with some GE, Hotpoint, and RCA models of stoves / ovens / ranges.
Write Your Own Review
Replacing the WB30T10155 GE Stove Haliant Burner:
Step 1: Unplug the stove to avoid the risk of electric shock.
Step 2: Remove the burner grate and set aside for safe-keeping.
Step 3: Carefully pry off the ignition switch bezel with a flathead screwdriver, being careful not to damage the trim around the switch.
Step 4: Turn the switch counterclockwise to remove it from its socket and disconnect the wires attached to it.
Step 5: Remove the screws that secure the burner base in place, then lift up and remove the base.
Step 6: Lift the igniter out of its slot and disconnect the wire.
Step 7: Place your new burner in the opening, making sure all the tabs fit securely into the slots in the stove top.
Step 8: Reattach the ignition switch and reconnect the wiring.
Step 9: Secure the burner with the screws you removed earlier and replace the bezel.
Step 10: Replace the burner grate, plug in the stove and test to ensure proper operation.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Step 1: Unplug the stove to avoid the risk of electric shock.
Step 2: Remove the burner grate and set aside for safe-keeping.
Step 3: Carefully pry off the ignition switch bezel with a flathead screwdriver, being careful not to damage the trim around the switch.
Step 4: Turn the switch counterclockwise to remove it from its socket and disconnect the wires attached to it.
Step 5: Remove the screws that secure the burner base in place, then lift up and remove the base.
Step 6: Lift the igniter out of its slot and disconnect the wire.
Step 7: Place your new burner in the opening, making sure all the tabs fit securely into the slots in the stove top.
Step 8: Reattach the ignition switch and reconnect the wiring.
Step 9: Secure the burner with the screws you removed earlier and replace the bezel.
Step 10: Replace the burner grate, plug in the stove and test to ensure proper operation.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.