WB28K10214 GE Oven Orifice

How to Replace the GE WB28K10214 Orifice SPUD LP 88L

Replacing your GE WB28K10214 Orifice SPUD LP 88L may be necessary for proper gas flow or for safety reasons. This SPUD is an important component for a kitchen or laundry room gas appliance, such as a range, oven, dryer, or water heater. Fortunately, replacing this SPUD is easy and can be done in just a few simple steps.

Tools & Materials Needed

- 1/4-inch hex wrench

- Flathead screwdriver

- New GE WB28K10214 Orifice SPUD LP 88L

Instructions

1. Turn off the gas valve that supplies the appliance, typically found near the appliance.

2. Use a flathead screwdriver to unscrew the old SPUD from the gas valve.

3. Install the new SPUD by hand. Make sure it’s firmly seated.

4. Secure the SPUD with the 1/4-inch hex wrench.

5. Turn the gas valve back on.

6. Test the appliance to ensure it is working properly.

7. If the appliance is not working properly, turn off the gas and contact a qualified technician.

Now you know how to replace a GE WB28K10214 Orifice SPUD LP 88L. Make sure to use caution when dealing with gas appliances and take all necessary safety precautions. With these steps, you should be able to get your appliance up and running in no time.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.