WB13X26360 GE Oven Spark Module Kit

Replacing the WB13X26360 GE Spark Module Kit

Step 1: Shut off power to stove. To do this, turn off the breaker associated with the stove, or unplug it from the wall.

Step 2: Locate the spark module. It can be found near the burner box on the back or under the stove.

Step 3: Remove the screws that secure the spark module. Use a screwdriver to remove the screws and set aside.

Step 4: Disconnect the wiring harness from the spark module. Carefully pull the wiring harness off of the spark module.

Step 5: Install the new spark module. Carefully connect the wiring harness to the new spark module and secure with the screws.

Step 6: Turn the power back on to the stove. Make sure the circuit breaker is switched back to the “on” position, or plug the stove back in.

Step 7: Test the spark module. Turn on a burner and check for sparking to ensure the spark module has been installed correctly. If there is no sparking, recheck the connections to make sure they are all properly connected.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.