WB13X24741 GE Oven Spark Module

DIY Guide to Replace the GE WB13X24741 Ignition Module

Replacing the GE WB13X24741 ignition module can be a difficult task for some and can require the help of an experienced technician. However, with the right tools and a little bit of know-how, this job can be done relatively easily by a homeowner. Follow these simple instructions to replace the WB13X24741 ignition module and get your appliances running smoothly once more.

What you'll Need:
-Phillips head screwdriver
-Needle nose pliers
-Replacement GE WB13X24741 Ignition Module

Instructions:
1. Make sure that the power is off to your appliance before starting the repair.
2. Using a Phillips head screwdriver, remove the screws inside the control panel of your appliance.
3. Carefully remove the front panel to expose the interior of the appliance.
4. Locate the old ignition module. It should be attached to a small bracket near the back of the appliance.
5. Use a pair of needle nose pliers to remove the connections from the wires on the old ignition module.
6. Carefully remove the module from its bracket and discard it.
7. Connect the wires to the new GE WB13X24741 ignition module.
8. Secure the module to its bracket with the supplied screws.
9. Carefully replace the front panel and reattach the screws.
10. Turn the power back on to your appliance.

Congratulations, you have successfully replaced the GE WB13X24741 ignition module!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.