WB02X10956 GE Charcoal Hood Filter
Part #: GEN WB02X10956
GE General Electric Hotpoint Microwave Range Vent Hood Charcoal Hood Filter WB02X10956
Size: 3 15/16" x 8 11/16" X 3/8"
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
Size: 3 15/16" x 8 11/16" X 3/8"
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
GE General Electric Hotpoint Microwave Range Vent Hood Charcoal Hood Filter WB02X10956
Size: 3 15/16" x 8 11/16" X 3/8"
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
Size: 3 15/16" x 8 11/16" X 3/8"
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
Write Your Own Review
DIY Steps to Replace the WB02X10956 GE Charcoal Hood Filter
1. First, turn off power to your range hood. This can be done by unplugging it from the wall or turning off the breaker.
2. Next, locate the filter. The filter is typically located in the top of the hood and may require the removal of a few screws to access.
3. Take out the old filter and discard it properly.
4. Identify the correct replacement filter (WB02X10956 GE Charcoal Hood Filter). Be sure to check the dimensions and specifications to ensure it fits properly.
5. Carefully place the new filter into place. Make sure it is firmly attached and secure.
6. Turn the power back on and test the hood to ensure it’s working properly.
7. Clean the area around the filter regularly to maintain its efficiency.
Following these steps will help you replace the WB02X10956 GE Charcoal Hood filter safely and efficiently.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. First, turn off power to your range hood. This can be done by unplugging it from the wall or turning off the breaker.
2. Next, locate the filter. The filter is typically located in the top of the hood and may require the removal of a few screws to access.
3. Take out the old filter and discard it properly.
4. Identify the correct replacement filter (WB02X10956 GE Charcoal Hood Filter). Be sure to check the dimensions and specifications to ensure it fits properly.
5. Carefully place the new filter into place. Make sure it is firmly attached and secure.
6. Turn the power back on and test the hood to ensure it’s working properly.
7. Clean the area around the filter regularly to maintain its efficiency.
Following these steps will help you replace the WB02X10956 GE Charcoal Hood filter safely and efficiently.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
