FQROPF GE Water Filter System Reverse Osmosis Filter Kit
Reverse osmosis filter kit works with some GE, and Hotpoint models of water filter systems.
Reverse osmosis filter kit works with some GE, and Hotpoint models of water filter systems.
Write Your Own Review
DIY Instructions to Replace the FQROPF GE Water Filter System Reverse Osmosis Filter Kit
1. Turn off the water supply to the Reverse Osmosis Filter System. This can be done by turning off the main water valve or turning off the shut-off valve located at the inlet of the water filter system.
2. Disconnect the water feed tubes from the inlet and outlet valves of the reverse osmosis filter system.
3. Unscrew the filter housing cap located at the bottom of the filter system.
4. Remove the old filters from the filter system.
5. Place the new filter into the empty filter housing and screw the cap back on.
6. Reconnect the water line tubing to the inlet and outlet valves.
7. Turn the main water valve or the shut-off valve back on.
8. Let the water run through the reverse osmosis filter system for a few minutes. This will flush out any residual debris that may have been present in the filter housing.
9. Test the water pressure and check for leaks at the inlet and outlet valves.
10. You're now ready to enjoy your clean, filtered water. Be sure to replace your filters regularly, as recommended by the manufacturer.
These simple steps will help ensure that your GE Water Filter System Reverse Osmosis Filter Kit runs efficiently and provides you with the clean drinking water you need.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Turn off the water supply to the Reverse Osmosis Filter System. This can be done by turning off the main water valve or turning off the shut-off valve located at the inlet of the water filter system.
2. Disconnect the water feed tubes from the inlet and outlet valves of the reverse osmosis filter system.
3. Unscrew the filter housing cap located at the bottom of the filter system.
4. Remove the old filters from the filter system.
5. Place the new filter into the empty filter housing and screw the cap back on.
6. Reconnect the water line tubing to the inlet and outlet valves.
7. Turn the main water valve or the shut-off valve back on.
8. Let the water run through the reverse osmosis filter system for a few minutes. This will flush out any residual debris that may have been present in the filter housing.
9. Test the water pressure and check for leaks at the inlet and outlet valves.
10. You're now ready to enjoy your clean, filtered water. Be sure to replace your filters regularly, as recommended by the manufacturer.
These simple steps will help ensure that your GE Water Filter System Reverse Osmosis Filter Kit runs efficiently and provides you with the clean drinking water you need.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
