Z-12638000000768 Avanti Washer Middle Hose Assembly

DIY: How to Replace the Avanti Products Z-12638000000768 Avanti Washer Middle Hose Assembly

Replacing the Avanti Products Z-12638000000768 Avanti Washer Middle Hose Assembly is a fairly easy DIY repair project. All that is needed is a few tools and you’ll be well on your way to getting your washing machine up and running again.

Here’s what you’ll need:

• Flat head screwdriver

• Philips head screwdriver

• Adjustable wrench

• Replacement hose assembly

• Pliers

Instructions:

1. Unplug the washing machine from the wall outlet.

2. Locate the old hose assembly. It should be located in the middle of the washer somewhere underneath the control panel.

3. Use the flat head screwdriver to loosen the screws that are holding the hose assembly in place. Once you have all of the screws out, carefully remove the old hose assembly.

4. Take the new hose assembly and insert it into place. Make sure it fits properly and is securely fastened down.

5. Use the Philips head screwdriver to secure the new hose assembly with the screws that you removed earlier.

6. Use the adjustable wrench to tighten the nut and bolt connections on the hose assembly.

7. Use the pliers to bend the clamps that are connected to the new hose assembly.

8. Plug the washer back into the wall outlet and make sure it turns on without any problems.

And there you have it! You have successfully replaced the Avanti Products Z-12638000000768 Avanti Washer Middle Hose Assembly. Congratulations!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.