WPW10185438 Whirlpool Ice Maker Cover

DIY Whirlpool WPW10185438 Door-Ice Maker Replacement

Replacing your refrigerator’s ice maker can be an intimidating task. However, with the right knowledge, you can replace the Whirlpool WPW10185438 Door-Ice Maker on your own. Before you begin, make sure you have the necessary tools, like a screwdriver, pliers, and a nut driver in order to complete the replacement.

Step 1: Turn off the refrigerator’s power by unplugging it from its power source. This will ensure that you don’t run into any electrical issues while replacing the ice maker.

Step 2: Remove the screws from the old Whirlpool WPW10185438 Door-Ice Maker. You may need to take out the front panel to gain access to the screws; this will depend on the type of refrigerator you own.

Step 3: Once the screws have been removed, you can then pull the old ice maker away from the refrigerator’s door. Be careful as you do this, as to not damage any fragile parts.

Step 4: Carefully move the new ice maker into place by connecting the electrical wiring. Double-check the wiring to make sure everything is connected properly.

Step 5: Secure the new ice maker to the door by tightening the screws. Use a nut driver if needed to secure the screws tightly.

Step 6: Finally, plug your refrigerator back in and turn the power back on. Test the new ice maker to make sure everything is functioning properly.

By following these steps, you can easily replace the Whirlpool WPW10185438 Door-Ice Maker yourself. Make sure to double-check your work and make sure all components are secured properly for the best results.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.