5701M754-60 Whirlpool Electronic Control Board

Replacing the Whirlpool 5701M754-60 CNTRL-ELEC

If your Whirlpool 5701M754-60 CNTRL-ELEC needs to be replaced, this guide will help you successfully do the repair and ensure optimum performance. Before beginning any appliance repairs, turn off the power source and make sure the area is clear and safe to work in.

Step 1: Gather the Required Tools

To replace the Whirlpool 5701M754-60 CNTRL-ELEC, you'll need a Phillips head screwdriver and a 7/16" nut driver.

Step 2: Remove the Bottom Panel

Start by laying the machine on its right side so you can access the bottom panel. Remove the screws securing the panel in place and then slide the panel off.

Step 3: Locate the CNTRL-ELEC

Once the bottom panel is off, locate the CNTRL-ELEC module. It will be mounted to the chassis near the top of the machine.

Step 4: Disconnect the CNTRL-ELEC

Using the nut driver, loosen the nuts securing the CNTRL-ELEC in place. Carefully disconnect the wires attached to the CNTRL-ELEC and lift the assembly out of the machine.

Step 5: Install the New CNTRL-ELEC

Place the new CNTRL-ELEC into the same spot as the previous one and then reattach the wires. Use the same nuts to secure the assembly in place.

Step 6: Reinstall the Bottom Panel

Once the CNTRL-ELEC is in place, you can slide the bottom panel back into place and secure it with the screws. Test the machine to make sure the repair was successful.

Conclusion

Replacing the Whirlpool 5701M754-60 CNTRL-ELEC is a straightforward process that only requires a few basic tools. Please keep in mind that any time you are working on an appliance, you should always turn off the main power source before beginning any repairs. If you have any questions or run into any issues, contact a professional for further assistance.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.