201468P Speed Queen Washer Mixing Valve
Mixing valve works with some Speed Queen, and Amana models of washing machines.
Mixing valve works with some Speed Queen, and Amana models of washing machines.
Write Your Own Review
DIY Instructions on Replacing the 201468P Speed Queen Washer Mixing Valve
Replacing a mixing valve in your Speed Queen washer can be a simple process if you have the right tools and know-how. The following steps will help guide you through replacing the 201468P Speed Queen washer mixing valve.
1. Unplug the washer from the power source before beginning any work.
2. Disconnect the water hoses from the supply lines. These are typically located behind the washer and will require a wrench or pliers to loosen. Use caution when removing these hoses as water may still be present.
3. Turn off the water supply at the wall or main water line leading to the washer.
4. Remove the screws holding the access panel with a screwdriver.
5. Locate the old mixing valve and disconnect it from the water lines. This will require a wrench or pliers, so use caution to avoid damaging the parts.
6. Install the new mixing valve in the same location as the old one. Make sure all the connections are tight and the valve is properly seated.
7. Reconnect the water lines to the supply lines using the appropriate wrench or pliers to secure them.
8. Turn on the main water supply.
9. Plug in the washer and test run it to make sure the new valve is working properly.
That’s all there is to it! With a few simple tools and a bit of DIY knowledge, you have now successfully replaced the 201468P Speed Queen washer mixing valve.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Replacing a mixing valve in your Speed Queen washer can be a simple process if you have the right tools and know-how. The following steps will help guide you through replacing the 201468P Speed Queen washer mixing valve.
1. Unplug the washer from the power source before beginning any work.
2. Disconnect the water hoses from the supply lines. These are typically located behind the washer and will require a wrench or pliers to loosen. Use caution when removing these hoses as water may still be present.
3. Turn off the water supply at the wall or main water line leading to the washer.
4. Remove the screws holding the access panel with a screwdriver.
5. Locate the old mixing valve and disconnect it from the water lines. This will require a wrench or pliers, so use caution to avoid damaging the parts.
6. Install the new mixing valve in the same location as the old one. Make sure all the connections are tight and the valve is properly seated.
7. Reconnect the water lines to the supply lines using the appropriate wrench or pliers to secure them.
8. Turn on the main water supply.
9. Plug in the washer and test run it to make sure the new valve is working properly.
That’s all there is to it! With a few simple tools and a bit of DIY knowledge, you have now successfully replaced the 201468P Speed Queen washer mixing valve.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
