MEE61841401 LG Range Stove Oven Burner Igniter
LG Electronics Sears Kenmore Range Stove Oven BURNER Igniter MEE61841401
Weight : 0.430900 lbs
Dimension : 6.456600 x 4.133800 x 2.244000
LG Electronics Sears Kenmore Range Stove Oven BURNER Igniter MEE61841401
Weight : 0.430900 lbs
Dimension : 6.456600 x 4.133800 x 2.244000
Write Your Own Review
Step 1: Begin by unplugging the range or turning off the breaker for the oven.
Step 2: Remove the oven door. To do this, open the oven door and on the bottom of the door, there will be two screws. Unscrew these and remove the door from the hinges.
Step 3: Locate the igniter. It will be a cylinder-shaped piece of metal located near the burner port.
Step 4: Disconnect the wiring at the terminal connection points. Using your fingers, gently pull apart the wires to disconnect them.
Step 5: Remove the burner igniter. Take note of the location of the screws and remove them. Carefully pull out the igniter, taking care not to damage any other parts in the process.
Step 6: Install the new burner igniter. Ensure that the mounting screws are placed into their corresponding holes. Plug in the wiring connections and attach them securely to their terminals.
Step 7: Reattach the oven door. Place the door back onto the hinges and secure it with the screws.
Step 8: Test the new igniter. Turn the oven on and set the temperature to 350 degrees. If the burner igniter lights up, then the installation was successful.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Step 2: Remove the oven door. To do this, open the oven door and on the bottom of the door, there will be two screws. Unscrew these and remove the door from the hinges.
Step 3: Locate the igniter. It will be a cylinder-shaped piece of metal located near the burner port.
Step 4: Disconnect the wiring at the terminal connection points. Using your fingers, gently pull apart the wires to disconnect them.
Step 5: Remove the burner igniter. Take note of the location of the screws and remove them. Carefully pull out the igniter, taking care not to damage any other parts in the process.
Step 6: Install the new burner igniter. Ensure that the mounting screws are placed into their corresponding holes. Plug in the wiring connections and attach them securely to their terminals.
Step 7: Reattach the oven door. Place the door back onto the hinges and secure it with the screws.
Step 8: Test the new igniter. Turn the oven on and set the temperature to 350 degrees. If the burner igniter lights up, then the installation was successful.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
