How to Replace Agitator Dogs in a Washing Machine: Step-by-Step Instructions

01. Shut Off the Electricity

• Unplug the washer from the wall outlet to ensure safety.
• Wear protective work gloves to avoid injury during the repair.

02. Remove the Agitator

• Pull off the fabric softener dispenser from the top of the agitator.
• Remove the agitator dust cap.
• Using a 7/16" socket with an extension, loosen and remove the agitator bolt.
• Carefully pull the entire agitator out and place it on a flat work surface.
• Tip: If your model has a spring retainer with a 1/2" square hole, use a 1/2" ratchet drive to remove it.

03. Remove the Agitator Dogs

• Pull the upper auger section off the agitator.
• Dump out the agitator cam from inside the auger.
• Remove the plastic bearing that holds the dogs in place.
• Take out the worn agitator dogs from the cam.

04. Install the New Agitator Dogs

• Push the new agitator dogs into the cam slots.
• Reattach the plastic bearing over the dogs to lock them in place.
• Insert the cam back into the auger.
• Align and place the auger back on top of the agitator assembly.

05. Reinstall the Agitator

• Position the agitator on the shaft inside the washer.
• Reinsert and tighten the 7/16" bolt with washer to secure the agitator.
• Replace the dust cap.
• Snap the fabric softener dispenser back into place on top of the agitator.

06. Restore Power to the Washer

• Plug the washing machine back into the electrical outlet to complete the repair.