WH11X29539 GE Replacement Drain Pump

Step 1: Unplug the washing machine and move it away from the wall. Lay down a towel to protect the floor.

Step 2: Remove the screws on the back of the washing machine that hold the access panel in place. You'll need a screwdriver for this step.

Step 3: Take off the access panel and locate the GE WH11X29539 drain pump and filter.

Step 4: Disconnect the electrical wires from the pump. Make sure you note where each wire goes for assembly.

Step 5: Loosen and remove the clamps that secure the hose to the drain pump. Use pliers or a wrench if necessary.

Step 6: Pull the hose off the pump and set aside the old pump.

Step 7: Place the new GE WH11X29539 drain pump and filter in the same location as the old one, being careful to orient it in the same way as the original.

Step 8: Reattach the hose to the new pump using the clamps. Secure it tightly.

Step 9: Reconnect the electrical wires to the new pump in the same order they were connected to the old pump.

Step 10: Reattach the back access panel of the washing machine and secure the screws.

Step 11: Move the washing machine back into position and plug it in to test the new pump.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.