Online Sale!
100% Guaranteed Genuine Parts
WD26X25104 GE Pump Drain
Variable speed drain pump assembly works with some GE, Hotpoint, and RCA models of dishwashers.
Weight : 2.39 lbs
Dimension : 8.62 x 7.09 x 5.43
Compatible Brands
About this product
Variable speed drain pump assembly works with some GE, Hotpoint, and RCA models of dishwashers.
Weight : 2.39 lbs
Dimension : 8.62 x 7.09 x 5.43
The following parts are replaced by this product
- WD26X20306
- WD26X22810
DIY Steps to Replace your GE WD26X25104 Variable Drain Pump Kit
1. Disconnect the power to the appliance by unplugging it or flipping the circuit breaker in the breaker box.
2. Remove the access panel from the back of the appliance. For some models, this may require removal of a few screws.
3. Locate the drain pump assembly. This should be located near the bottom of the appliance and is often held in place by two screws.
4. Unscrew the two screws and remove the old pump assembly.
5. With the old assembly removed, you can now inspect the hoses and tubing to check for any signs of damage or corrosion. If any part appears damaged or corroded, it should be replaced before the new drain pump assembly is installed.
6. Take the new drain pump assembly and connect the inlet and outlet tubes to the correct fitting on the pump.
7. Secure the new assembly in place with the two screws and replace the access panel.
8. Reconnect the power to the appliance and test the new drain pump assembly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
1. Disconnect the power to the appliance by unplugging it or flipping the circuit breaker in the breaker box.
2. Remove the access panel from the back of the appliance. For some models, this may require removal of a few screws.
3. Locate the drain pump assembly. This should be located near the bottom of the appliance and is often held in place by two screws.
4. Unscrew the two screws and remove the old pump assembly.
5. With the old assembly removed, you can now inspect the hoses and tubing to check for any signs of damage or corrosion. If any part appears damaged or corroded, it should be replaced before the new drain pump assembly is installed.
6. Take the new drain pump assembly and connect the inlet and outlet tubes to the correct fitting on the pump.
7. Secure the new assembly in place with the two screws and replace the access panel.
8. Reconnect the power to the appliance and test the new drain pump assembly.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
Write Your Own Review