WD13X10045 GE Dishwasher Handle Actuator
GE General Electric Hotpoint Sears Kenmore Dishwasher DOOR HANDLE ACTUATOR WD13X10045
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
Weight : 0.034800 lbs
Dimension : 4.566900 x 2.992100 x 0.354300
Product Details
Reviews
Replaces Parts
Installation Instructions
Compatible Models
Compatible Brands
GE General Electric Hotpoint Sears Kenmore Dishwasher DOOR HANDLE ACTUATOR WD13X10045
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
We are a Factory Authorized Parts Distributor for General Electric Hotpoint. Trust us for all of your General Electric Hotpoint appliance parts and accessories needs.
Weight : 0.034800 lbs
Dimension : 4.566900 x 2.992100 x 0.354300
Write Your Own Review
The following parts are replaced by this product
- WD13X10008
1. Unplug your dishwasher from the power source and turn off the water supply.
2. Locate the screws holding the dishwasher door and remove them using a screwdriver.
3. Carefully remove the outer case of the dishwasher door and set it aside.
4. Disconnect the wiring harness connected to the handle actuator.
5. Unscrew the two screws holding the handle actuator in place.
6. Remove the handle actuator and discard it.
7. Install the new handle actuator by securing it in the same two screws used to hold the old actuator.
8. Connect the wiring harness to the new handle actuator.
9. Place the outer case of the dishwasher door back over the actuator.
10. Secure the door with the screws and plug in the dishwasher.
11. Turn on the water supply, and your replacement of the handle actuator is complete.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
2. Locate the screws holding the dishwasher door and remove them using a screwdriver.
3. Carefully remove the outer case of the dishwasher door and set it aside.
4. Disconnect the wiring harness connected to the handle actuator.
5. Unscrew the two screws holding the handle actuator in place.
6. Remove the handle actuator and discard it.
7. Install the new handle actuator by securing it in the same two screws used to hold the old actuator.
8. Connect the wiring harness to the new handle actuator.
9. Place the outer case of the dishwasher door back over the actuator.
10. Secure the door with the screws and plug in the dishwasher.
11. Turn on the water supply, and your replacement of the handle actuator is complete.
Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.
