Roper Appliance Parts

This Range Bake Element keeps your oven heating properly. The element is fastened into the back of the oven by two phillips screws. The main reason for replacing the heating e ...lement is if it has shorted out and is no longer heating the oven sufficiently. When removing the old element and disconnecting the wires, make sure you don't allow the wires to fall back into the oven wall. This bake element measures 16-5/8" wide x 15-3/4" long and has 3" terminals to the mounting bracket with 1-3/4" between terminals. Replacing this part will require basic hand tools, some disassembly of the range and novice repair experience. You must unplug the range or shut off the house circuit breaker for the appliance before installing this part.Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) Range Bake Element• Tools Needed: Multi screwdriver Read More Read Less

This is a genuine OEM part that works for some models of Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models.

This Range Broil Element is a replacement part with 1/4" push-on wire terminals that provides constant heat to the broiler when cooking. If your broiler does not heat up prope ...rly, replacing this part may alleviate the issue. Reuse the existing support bracket for the element if your oven has one when installing this part. Replacing the element will require basic hand tools, some disassembly of the oven and novice repair experience. You must unplug the oven or shut off the house circuit breaker for the appliance before installing this part. Be mindful not to let the wires connected to the current part fall back inside the oven when you disconnect them; retrieval of the wires will require additional steps during the installation.Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) Range Broil Element• Tools Needed: Phillips-Head screwdriver or power driver Read More Read Less

This Top Load Washer Drain Pump removes water from your top-load washer during the drain portion of the wash cycle. This pump mounts directly to the washing machine’s motor ...with two clips (item WP8546127). If your washer doesn’t drain properly, replacing this part may alleviate the issue. Replacing this part will require basic hand tools, some disassembly of the washer and novice repair experience. You must unplug the washing machine or shut off the house circuit breaker for the appliance before installing this part. Also make sure you turn off the hot and cold water supplies. Helpful Tip: We also recommend using affresh® Washing Machine Cleaner Tablets* (item W10501250) once a month to help reduce odor-causing residue that can build up in your washing machine's drain without proper care. *affresh® brand products are owned and distributed by Whirlpool Corporation. Recommended Item: The Repair Manual (item 4313896) for your washer is a useful reference when replacing this part.Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) Top Load Washer Drain Pump• Tools Needed: Multi screwdriver, standard pliers Read More Read Less

This is a genuine OEM part that works for some models of Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models.

• This EDR5RXD1 Water Filter (Pink) is specifically designed to diminish up to 99% of lead, ensuring enhanced safety and purity for your drinking water. • Tested ... and certified, it effectively eliminates 27 types of contaminants including lead, pesticides, pharmaceuticals, and waterborne parasites, meeting NSF standards 401, 53, and 42. • Engineered to provide water that is not only clean but also has a fresh and pure taste. • Each EVERYDROP filter replaces 1,500 plastic water bottles saved, making it an environmentally conscious option. • Used in top freezer refrigerators. Filter compartment is in the bottom left corner of the refrigerator. • Certified to fit these leading refrigerator brands: Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper. • For the best quality water, it's recommended to replace the filter every six months or 120 gallons to maximize contaminant reduction. Read More Read Less

This Refrigerator Defrost Thermostat is a safety device that clips onto the evaporator in the freezer. The thermostat turns off the defrost heater in case it gets too warm in ...the freezer section. If your refrigerator does not defrost, replacing the thermostat may alleviate this issue. To access the part, open the freezer door and remove the shelves, mounting brackets (if they release), and the ice bucket. After you remove the back panel, the defrost thermostat is mounted to the end of the evaporator. Replacing the element will require basic hand tools, some disassembly of the refrigerator and novice repair experience. You must unplug the appliance or shut off the house circuit breaker for the appliance before installing this part.Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) Refrigerator Defrost Thermostat• Tools Needed: Multi screwdriver, wire splicing tool Read More Read Less

This is a genuine OEM part that works for some models of Whirlpool, Jenn-Air, Kenmore, KitchenAid, Maytag, Amana, Magic Chef, Admiral, Norge, and Roper models.

The Dryer Timer controls the electrical components of the appliance and duration of its drying cycles. If any of the contacts in your appliance’s timer have burned out, or i ...f the motor inside the unit shorted out and the timer is no longer functioning, replacing this part may alleviate these issues. Note that this item does not include the timer knob (part number W10711289). Replacing this part will require basic hand tools, some disassembly of the dryer and novice repair experience. You must unplug the dryer or shut off the house circuit breaker for the appliance before installing this part.Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) Dryer Timer• Tools Needed: Multi screwdriver Read More Read Less

The SxS Refrigerator Water Inlet Valve Assembly allows water to enter the refrigerator’s water dispenser and ice maker. If one of the solenoids in the original unit is bad, ...it will prevent water from flowing into the ice maker and dispenser. If the icemaker of your appliance stops making ice, no water flows from the dispenser or it flows constantly, or if you notice water at the bottom of the fresh food compartment, the water inlet valve could be malfunctioning and need to be replaced. This assembly includes (1), water inlet valve, (1) piece of plastic tubing, (1) plastic union and installation instructions. Installing this part will require basic hand tools, some disassembly of the refrigerator and novice repair experience. You must unplug the refrigerator or shut off the house circuit breaker for the appliance before installing this part. Also turn off the refrigerator’s water supply before you begin. Helpful Tips:The replacement part may look different than the original in your appliance, but the part will still function the same. We do not recommend disassembling your appliance’s current water inlet valve to clean it due to the risk of failure after the repair.Part Specification• This product is a Factory Certified Part. These three words represent quality parts and accessories designed specifically for your appliance. Time tested engineering that meets our strict quality specifications• This product is a replacement part• Package contains (1) SxS Refrigerator Water Inlet Valve Assembly• Tools Needed: Multi screwdriver, 1/2" wrench Read More Read Less